Special thanks to m0ondoggy for a great tutorial.

Each Section contains a link to the build tutorial. Click on the link to watch the video. A preview hase been added as an example.

Part 1: Pressing out the barrel pin

*NOTE: the 1/16 drill bit is installed upside down in the drill press chuck so that the flat end is pushing on the spring*

Part 2: Removing the barrel

Part 3: Demilling the trigger guard

Part 4: Removing the receiver stubs

Part 5: Drilling the old rivets in the trunnions

Part 6: Tapping the old rivets out of the trunnions

Part 7: Test fitting of the magazine and trigger guard and riveting the trigger guard

Part 8: Drilling the front trunnion holes in the receiver

Part 9: Drilling the rear trunnion holes in the receiver

Part 10: Pressing the front rivets and shortening the rear rivets

Part 11: Pressing the rear trunnion rivets

*NEW*Part 12: Drilling The Scope Rail

*NEW*Part 13: Riveting the Scope Rail

*NEW*Part 14: Pressing in the barrel

Part 15: Checking Headspacing

Part 16: Reinstalling the barrel pin